I was wondering if I should buy it. But I was wondering if it'd work since I have a Marineland Penguin Bio Wheel 200 power filter. Or will it block the water output. Anyone have any experience with it?
__________________
~Tanks
55 gallon FW - 1 Tiger Oscar
Most of the glass canopies have a plastic strip across the back that can be cut to accommodate your filter. These are wider with the larger canopies to allow more room for hardware at the back of the aquarium. You should be able to find some info on how wide the plastic strip is to determine whether or not it will allow enough space for your filter.
I'm assuming this would be for the 55g tank in your sig. If so I used the same top on my 55g when I had one and was able to use my power filter without a problem. It wasn't the same filter as yours though.
46g SW bowfront, 196W Coralife PC fixture, 2x 100W heaters on a Johnson Controls controller, AquaC Remora Pro skimmer (Mag3 pump), Marineland Magnum HOT cannister, Marineland 100 Penguin Biowheel (for transfer to QT), and a Koralia 2.
70 lb of live rock, and 4+" sand bed.
Various nassarius, turbo, trochus, astrea snails, a Tongan conch, and 4 small hermits, as well as a skunk cleaner shrimp.
3x Blue Chromis, Bangaii Cardinal, O.Clown, and a yellow clown goby.
Mostly LPS corals, with a few SPS thrown in high in the tank.
Pretty sure it'll fit. I use a modified version of that glass canopy on my 46g and I run a Penguin Biowheel 100 on it. I believe the part of the filter that hangs in the tank has the same footprint for both the 100 and 200, so it should work fine. Purrbox is correct in that the plastic strip can be cut to suit... or just left off if desired.
My Tanks
Linear Mode
