Hi- newbie here. I have a 3.5 gal. tank with heater set at 78, low flow filter, lights, 1 tall silk plant, pea pebble substrate, betta leaf & terra cotta pot in it, running for about 20 days. I had added API Sress Coat, API Quick Start, & Seachem Stabiliy. Then about 12 days ago found out that I needed to add Dr Tim’s Ammonium for it to properly cycle. But I neglected to check it daily with Master test kit- only checked it a few days after adding ammonia, it registered on the chart as having ammonia. Checked today & readings are all 0 for ammonia, nitrites & nitrates. I messed up by not doing daily tests. Do I just add more ammonia at this point- start over? Just order Seachem Prime. I have not bought a betta yet I feel very enept bc should have been checking water daily to see any spikes in water. . Thank you!