|
co2 hardware help!
folks,
Just got my MKII Perma seal from Rex Griggs as well as tubing and brass check valve. I have a question on the installation of the Perma seal on a Milwaukee MA957regulator.
The whole in the center of the brass washer does not fit over the regulators male end. The rubber o-ring in the brass washer does sit on top of the regulator lip. Is this the way the Perma Seal sits?
Second-The nylon washer that comes with the regulator is beveled-does anyone know which way this washer goes? The instructions dont mention a particular direction although one way it presses onto the regulator and the other way it doesnt. Not saying thats correct!
I know I only need one seal, Rex's or the nylon. i just need to know which way they install. Thanks
Sounds simple but to me it just doesnt seat correctly.
thanks
__________________
|
Linear Mode
