Question on replacing stock pump on an AP 24 with a Maxijet

[dgness]

I am going to replace the stock pump in my Aquapod 24 with the Maxijet 900.
When I do the swap, the out take outlet on Maxijet pump is smaller the the stock pump out take outlet. Which makes the the tubing supplied with the Aquapod too big a fit over outlet. Should I just buy a small clamp to attach it to the Maxijet?
Anybody that has made the switch, please let me know what you did to resolve that issue.

Thanks in advance.

[roka64]

I'm going to move this to the General Hardware/Equipment section, where I think you will get a lot more responses.