Search results

So i ordered a new tank which is due to be delivered tomorrow:) in cm the dimensions are 100 width 31 deep and 47 high i am just wondering if you think this would be big enough for my 3 large angels and my large clown loach all feedback appreciated :fish1: :thanks:

All sorted thanks for all the comments the petshop had an uplift tube which the powerhead sits on perfect :)

I will try this before i go down to my local petshop im going to take the powerhead down to see if they have a better fit and about the rams they are very nice fish my dad has a 500gallon cichlid tank but with my tank been much smaller and also been a community tank i thought they would be very...

Ok i see what u mean i have tried removing the white bit at the top of the tube but its still too thin to take all of the powerheads intake tube into think i will call down to the petshop tomorrow and see if they have a wider uplift tube the powerhead will fit in properly. Thanks for the reply

Ok i will try this thanks a lot, but will my undergravel filter be as efficent with just an air stone on 1 side of the tank i used to have an air stone in both uplift tubes at seperate sides of the tank until i replaced 1 side with the powerhead to add a bit of a current to the water

Just a quick update to let everybody know whats in my tank not sure on the capacity its 4ft x 2ft x2ft i use an undergravel filter whith a powerhead on one of the uplift tubes standard air stone in the other uplift tube and in the tank i keep. 1 pleco large 2 clown loach 1 large 1 medium size 3...

Thanks for the quick reply i have taken a picture my issue is with the bottom of the powerhead where it is sat on the uplift tube think you can just about see the holes which suck up water i was thinking about covering them with kitchen foil or something similar but apparently this is a bad idea...

Just wondering if anybody could give me so advice on what i could use to cover the top hole on my powerhead as i have it sat on an uplift tube from my undergravel filter but the powerhead is not sat all the way down the uplift tube as its a bit thinner than the powerhead sorry for the bad...