Search results

Hard its a acro

A better pic

It has some green blue and purple to it

Hey I need some advice on getting a new return pump. My tank is 180g sump is 30gal I run my gfo reactor and my cal reactor off the return. I had a mag 24 in there and seems to have done fine up till yesterday when the shaft snapped. This is the second time its had a problem. What would be a good...

Does anyone know what is causing this to show up in my tank? Its like a brownish gold showing up on the sand and the returns and on the sand its kind of thick mat. I do use rodi water with a reading of 0 tds the tank is 3 years old phosphates have always been about .33ppm and I have gotten them...

I dont I thaw the mysis in some tank water and dump it in

What would you recommend to feed that wont kick the phosphates up. Is a pellet food better?

Mix my own. I have tried io, reef crystals and salinity. Probably going back to IO since its cheaper and dont need the extra cal or alk since my reactor does that part

I have a tds meter on my rodi and it reads zero. I feed frozen twice a week and flake daily. I tried everyother day on flake made no change

It grows ok not to fast but it does tank is 180gal pen with adhi sump and evo 400 skimmer I have 2 mp40 run on one side and 2 other cheap pumps on the other side. Theres about 400lbs live rock in the tank at the moment close to that in live sand.

I use to do about every 3 weeks 40gals but now thats slowed down do to price of salt was geeting rc for 39 for 200gal box now it like 69 so mighy go back to plain instant ocean since I dont need the extra alk cal mag in my salt since the reactor does that for me. What do u think? Im self...

Ok I plan to turn up the blues slowly. On the phosphates I do have a sponge filter just before the return pump can I take that out could that cause phosphates? I am running a fuge. On the first chamber is the skimmer and heater then second chamber I have rock a little sand and chaeto then...

Ok whats good for keeping the phos down. I can turn up my lights what should the whites and blue be both the same, one more than the other? These are 200w lights at 2 watt each

I wash them everytime I clean the reactor since they dont make a replacement for the unit.

I do use rodi water. I tried awhile back gfo and could only gdt them down to .33 and I dont over feed.i dont have algae growning in the the tank. Temp on tank is 78 all the time should I increase it to 79 or 80?

Any one have any ideas why my tank isn't really growing? The tank is 3yrs old all the same corals a mixed of sps and lps. I run leds and a cal reactor nothing flex's and been stable since setup. None of my sps plate out or grow up they stay the same. My levels are below. As for as par the leds...

Tank is 180g 2 mp40 2 EVO 250w LEDs Calcium reactor Ev-240 skimmer Phos reactor running BRS GFO Temp 78 Salinity 1.025 Ph 8.3 Mag 1375 Nitrite 0 Nitrate 20 Alk 4 mlq Calcium 420 Phos .14ppm

So over the last few weeks my chalices have been burning out starts at the edge and moves in and its only been my expensive ones so far go figure :( all the tank levels are normal. Any ideas? Nothings been added or changed other that gfo but it started before that.

Ok so just wanted to thank u again for the help I finally got it to hold. It took putting the ph at 6.3 and the eff at 45mil per minute. So now thats its stable how fast should I raise the alk up?

Here is a little better pic. They were way in the sand. They dont look like the pics of flat worms i just looked at. There oval brownish red with a black center

What damage do they do and how do i get rid of them?

So i was looking for a coral that fell off and i found a old disc in the sand. I took it to find these on it.

Ok still no luck I went from 140ppm on wed after my water change to 128ppm tonight. I checked the eff coming out of the reactor and its at 225ppm and the reactor instructions says a value between 225ppm and 357ppm how do I get it higher? If I slow the flow my alk will drop in the tank. The...

My tank is a little over a year old and I have noticed nitrates are starting to rise on the API kit its hard to tell but its either 5.0 or 10ppm they look like the same color. Also phosphates I can't get below .46ppm on the Hanna checker. I have tried the Kent phosphate sponge which pulled it...

I think so but won't know for another day or so. The last too days its held 123ppm on my Hanna checker. But I did my 2 week water change and waited 30 min and check it with the Hanna and it jumped to 140ppm so I don't know if it just hasnt turned enough water over or what. I'll check it again...