The friendliest place on the web for anyone with an interest in aquariums or fish keeping!
If you have answers, please help by responding to the unanswered posts.
See posts with no answers
Trusty old clamps hold the joints tight will I put in the screws.
Next I cut the lengths of timber to the length of the aquarium minus the dimension of the cabinet covering on each side. In this case the aquarium is
Glued and screwed together. To ensure everything is square I measured the diagonals and pushed and pulled from the corners until they were the same di
After gluing and screwing the front and back frames, I joined them together with four lengths of timber of sufficient length to allow the 600mm wide s
Trusty old clamps hold the joints tight will I put in the screws.
Next I fitted the back and floor panels cut from the marine ply. Note that the stand is upside down in this photo and has been painted.
Unfortunately I neglected to photograph the fitting of the panels; thankfully it’s a pretty straight forward procedure. Basically I used construction
Instead of using polystyrene I decided to use black rubber floor mats for the tank to rest on. The mats are easily cut with a sharp knife and a steel
Hooked on Fish

Trusty old clamps hold the joints tight will I put in the screws.

Media information

Album
Building a Custom Aquarium Stand
Added by
Hooked on Fish
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom