ReefRaff
Aquarium Advice Addict
That the ripping fence dosn't always stay on the backside of the saw. I.E when i send some wood down along the fence the back tends to move outward.
It's not a gear driven fence like the older and more expencive models. It has a little arm that wraps around the lip of the table, then sinches down to hold it, but doesn't.
I was thinking of cutting some acrylic panles, and wondering if i should just clamp a peice of plywood down to the table and useing that? or back the fence up with some plywood, and doing it that way?
Any other ideas?
TIA.
It's not a gear driven fence like the older and more expencive models. It has a little arm that wraps around the lip of the table, then sinches down to hold it, but doesn't.
I was thinking of cutting some acrylic panles, and wondering if i should just clamp a peice of plywood down to the table and useing that? or back the fence up with some plywood, and doing it that way?
Any other ideas?
TIA.