dansemacabre
Aquarium Advice Freak
OK, I'll have 2 Fulham Workhorse 7s for my PCs, and 3 electronic MH ballasts. The reflector came with the mogul sockets and braces, with the braces riveted to the reflector. There's a hole in the middle of the brace and the reflector allowing the wires to go through to the side behind the reflector. I'm going to use U-nails (not hammered in all the way, but enough to keep the cables raised off the reflector) to support them. It came with about 8-10" of wire already wired to the mogul sockets. So, my question is this...it's not long enough to make it out of the hood, so how should I connect the wires to the ballast? Electrical tape, a cap, a cap filled with a non-conducting paste that will harden and keep moisture out, or should I just drill a hole in the top and pipe the wires out the top? I really don't want to do this, as it will make the hood look bad, but if I have to, I have to. My other question, where should I mount these ballasts? With the PCs, I have 8' moisture-proof endcaps, so I have about 8' to work with. Underneath the tank in the stand? On the wall off to the left (the right is where the sump is)? Where's a good place to keep them cool and away from moisture. Thanks!!