ccCapt
SW 20 & Over Club
Good eye Ziggy.
Looking at those pics even more, are both sides cut out? It looks like maybe the right side only has a section missing but the left side totally gone?
I've seen where people cut out their center cross brace and replace it with acrylic. The center brace has alot more stress on it than the side trim. I think if you got some Weld-On or a good epoxy, you can cut a strip of acrylic the entire length of the trim, probably about 18", and just glue it on the TOP the existing piece and the top of the front and back edge of the trim. I would not fill it before doing something first. Either try to repair it or contact the manufacturer for a replacement.
Looking at those pics even more, are both sides cut out? It looks like maybe the right side only has a section missing but the left side totally gone?
I've seen where people cut out their center cross brace and replace it with acrylic. The center brace has alot more stress on it than the side trim. I think if you got some Weld-On or a good epoxy, you can cut a strip of acrylic the entire length of the trim, probably about 18", and just glue it on the TOP the existing piece and the top of the front and back edge of the trim. I would not fill it before doing something first. Either try to repair it or contact the manufacturer for a replacement.
That is the 2x4 frame I believe, not holes cut in the plywood. I think the stand is upside down in a few of those pics where you see a solid top.Looks great. Have a question though, why the 3 holes in the top and not just a solid panel for the tank to rest on? Will it be drilled through the bottom? Structurally not difference, just curious.