neilanh
Sliced Bread
Alright, I'm quite frustrated here.
I have an RO/DI unit, purchased from ebay, 6 stage, 100gpd. It's a few months old, but I've probably only put 200 gallons through it so far. Now that my tank is actually going up, I'm really starting to use it, for obvious reasons. The thing is slow as dirt. I've seen paint dry faster. What can I do to help it out.
I don't know my water pressure, I'm looking for a gauge to measure it. I expect to find it's in the low range. And of course, this time of year, the water temp on the inlet is low, mines at 45 deg F.
I'd guess that I'm only producing about 20gpd right now, and that's just not acceptable.
My waste water line has a nice, constant decent stream of water, and out of the pure water line I get drops, about 5 per second.
any suggestions? It's going to take a week to fill my tank at this rate.
I have an RO/DI unit, purchased from ebay, 6 stage, 100gpd. It's a few months old, but I've probably only put 200 gallons through it so far. Now that my tank is actually going up, I'm really starting to use it, for obvious reasons. The thing is slow as dirt. I've seen paint dry faster. What can I do to help it out.
I don't know my water pressure, I'm looking for a gauge to measure it. I expect to find it's in the low range. And of course, this time of year, the water temp on the inlet is low, mines at 45 deg F.
I'd guess that I'm only producing about 20gpd right now, and that's just not acceptable.
My waste water line has a nice, constant decent stream of water, and out of the pure water line I get drops, about 5 per second.
any suggestions? It's going to take a week to fill my tank at this rate.