OP
OP
TMRC Exotics
Aquarium Advice Addict
A few hours later and the royal gramma has been hidden since introducing him. He is hanging behind the rock work. I also made catching the scooter blenny sound easy, it was not. I had to remove much of the live rock so while I had it out I rescaped alot of the tank. I also broke a 7 pound chunk into small pieces and spread it through the tank. It opened the tank up a lot and leaves some room for the polyp covered rocks I'll be adding once were ready to start with corals.
I'll also have to get positive IDs on the hermits before adding anything sensitive. They were all supposed to be scarlet leg hermits but they started hiding when she started netting and I believe two may be different though I haven't gotten a good enough glimpse since adding them.
On to the nano, for some reason this tank gets cloudy each time I mess with it. I'm not sure what's going on but after each water change it becomes very cloudy. The top fin 10 filter wasn't doing the job so I switched to a fluval aqua clear 20 with fresh carbon(while preserving the bio sponge from the tf10). Once the carbon expires I'll switch to purigen.
Any opinions on the source of cloudiness?
The co2 system is pumping nicely into the tank, im still just using an air stone under the filter output to disperse co2, i was planning to run it into the output of an in tank filter or powerhead but i cant find anything small enough for the nano. I'm still using gravel but hate it. I plan to plant the hair grass and bacopa tonight if things go according to plan.
I'll also have to get positive IDs on the hermits before adding anything sensitive. They were all supposed to be scarlet leg hermits but they started hiding when she started netting and I believe two may be different though I haven't gotten a good enough glimpse since adding them.
On to the nano, for some reason this tank gets cloudy each time I mess with it. I'm not sure what's going on but after each water change it becomes very cloudy. The top fin 10 filter wasn't doing the job so I switched to a fluval aqua clear 20 with fresh carbon(while preserving the bio sponge from the tf10). Once the carbon expires I'll switch to purigen.
Any opinions on the source of cloudiness?
The co2 system is pumping nicely into the tank, im still just using an air stone under the filter output to disperse co2, i was planning to run it into the output of an in tank filter or powerhead but i cant find anything small enough for the nano. I'm still using gravel but hate it. I plan to plant the hair grass and bacopa tonight if things go according to plan.
