graceinhim
Aquarium Advice Apprentice
- Joined
- May 10, 2009
- Messages
- 10
I bought a Coralife RO/DI Pur Flo 3 50GPD unit about 2 years ago when I was last into salt. When I shut down my salt tank about 6 months ago I took the coralife apart And stored the membrane in the case in the fridge. Well I am getting back into Saltwater and am trying to get this RO Filter running again.
I'm sure I have all the plumbing right as far as sequence. I have tested pressure upto the RO Unit and everything runs fine. EVerytime I plumb it through the RO Unit I get no production and it usually pops a seal/hose and leeks. With nothing coming throught the filter.
Is it possible that the RO Membrane is shot and if so would that stop water coming through completely and cause a pressure burst?
I Kinda want to figure out exactly what it is before putting money down on a new membrane or even worse a whole new filter.
Thanks
I'm sure I have all the plumbing right as far as sequence. I have tested pressure upto the RO Unit and everything runs fine. EVerytime I plumb it through the RO Unit I get no production and it usually pops a seal/hose and leeks. With nothing coming throught the filter.
Is it possible that the RO Membrane is shot and if so would that stop water coming through completely and cause a pressure burst?
I Kinda want to figure out exactly what it is before putting money down on a new membrane or even worse a whole new filter.
Thanks