threnjen
Aquarium Advice Addict
OK I would let your nitrites get to 1.0ppm but with this recommendation, add sodium chloride (aka table salt, aquarium salt, kosher salt) at a rate of 1 level tsp per 10 gallons of water. It is a very, very negligible amount of salt (for example the "official" aquarium salt dosage calls for 1 Tbsp per 5 gallons so this is much less). Don't make them mounded, just level. If you are using table salt or kosher salt check the label. There is going to be some kind of anti-caking agent. Most of them are ok except for "Yellow Prussiate of Soda" or something like that. It has Prussiate in the name. Iodized or non-iodized is fine (there are a lot of stupid myths about salt out there, so people are inevitably going to protest what I'm saying, but I'll pull out my references if needed)
But if you see EITHER ammonia or nitrite hit 1.0 you need to do a water change.
Only add new salt when you do a water change and make sure it's the appropriate dosing (if you pull out 50% water, add back 1/2 tsp per 10 gallons). Don't add salt if topping off evaporation.
Once you are done with the ammonia phase and only have nitrite you can continue this method as needed.
Prime is also good to detoxify ammonia and/or nitrite but it needs to be dosed every day, so this can be more expensive. But if you have concerns you could do it along with the salt.
But if you see EITHER ammonia or nitrite hit 1.0 you need to do a water change.
Only add new salt when you do a water change and make sure it's the appropriate dosing (if you pull out 50% water, add back 1/2 tsp per 10 gallons). Don't add salt if topping off evaporation.
Once you are done with the ammonia phase and only have nitrite you can continue this method as needed.
Prime is also good to detoxify ammonia and/or nitrite but it needs to be dosed every day, so this can be more expensive. But if you have concerns you could do it along with the salt.
Last edited: