I have a retrofit vho kit and have a question regarding wiring of the end caps.
The end caps have a rubber piece on the bottom and both are connected by two screws. The two screws then connect the end cap to the plastic mount which is then screwed into the canopy, fixture, or wooden blocks with two more screws to support the bulbs.
My question is where do the wires go? Are they placed between the rubber piece and the screws or between the end caps and the rubber piece?
Though there are many ways to make the connections I assume there is only one correct way. Below I list three possibilities form the likeliest to the least likely.
1. The likeliest connection is end cap --> wire ---> rubber piece ---> plastic mount ---> screws.
2. End cap ---> rubber piece ---> wire ---> plastic mount ---> screws.
3. The least likely is end cap ---> rubber piece ---> plastic mount ---> wire ---> screws.
Which is the correct connection?
The end caps have a rubber piece on the bottom and both are connected by two screws. The two screws then connect the end cap to the plastic mount which is then screwed into the canopy, fixture, or wooden blocks with two more screws to support the bulbs.
My question is where do the wires go? Are they placed between the rubber piece and the screws or between the end caps and the rubber piece?
Though there are many ways to make the connections I assume there is only one correct way. Below I list three possibilities form the likeliest to the least likely.
1. The likeliest connection is end cap --> wire ---> rubber piece ---> plastic mount ---> screws.
2. End cap ---> rubber piece ---> wire ---> plastic mount ---> screws.
3. The least likely is end cap ---> rubber piece ---> plastic mount ---> wire ---> screws.
Which is the correct connection?