Thanks for the reply. So what you are saying is that I would hook up the pump in 600-2 to the sump in 600-3? And what looked like to me a power head is a Maxijet with flow mod? Would I hook that up like a power head would hook up on a fresh water tank without the under gravel filter?
I guess I should have put in the original post what I believe the parts are and if I am wrong if you could correct me.
Picture 600-1 (top):
RO with cables. I do not know anything really about
RO's so any help would be appreciated
(middle): Various heaters of which I do not know if I need all those or not. Testing kit, chemicles, over the back filter and timer
(bottom): Various air pumps of which I do not know if I need that much or more
Picture 600-2 The black boxes are wired to the silver/white cylinder. This looks like light sockets and was told by the person who gave it to me they were grow lights. I could not find wattage on them and do have 2 bulbs that go in them and there is no wattage on those either. The power head or Maxijet and a pump
Picture 600-3 This I believe is the sump and below it is a sheet of glass of which I also believe goes at the top of the tank for support. Can you tell me if that is correct and if so if it is necessary as I would have to strip the silicone off and re-silicone it in place
Picture 600-4 This is quite dirty and am in the process of cleaning up. It has several foam filter type squares on the left side and a thick paper like lining on the right bottom
As a note I have joined a few forums and posted the same pictures and this is the only one to receive any response. I do appreciate all the help.
Linear Mode
