Ok so here is where i am at with this build.
i just ordered from the website above that X linked. I even found the reducer bushing to go from 1 inch to 3/4. I got the 3/4 inch hookup to that reducer and the 3/4 to 1/2 inch splitter for the locline. I got two segments of tube and 2 flare nozzles. SOooo i think the return section is finished. Coming ups I believe so will have it this week.
I hooked up with a local guy last night at the meeting and he will do the drilling as soon as I get the bits. No one had the right size bits so I have to get my own.
I plan on ordering a 45mm bit and a 60mm. that should be 1 inch and 1.5 inches respectively.
I had alot of problems finding the right sizes, I've been going back and forth between glass-holes, BRS, ebay and amazon trying to figure out the right ones to get. It seems glass-holes has bits that are just a tiny bit larger than what everyone else sells. I am assuming its because they are for sch40 or 80 pvc bulkheads. If that is a bad guess let me know. its been driving me nuts. lol
The only other thing is the actual bulkheads. I know I need the 1.5 and 1 inch ones but since I am confused kinda I am going to order both threaded on each end. that seems to be the best fit, but I could be wrong. lol The only negative is that i cant find "short" ones other than from glass-holes and I dont think they will fit if I get the smaller diameter drill bits.
Anyone know of someplace I can get the short bulkheads? AND if I dont find them can I just cut off some of the overflow bulkhead to make it shorter?
Thanks, I know this post is longer than most but I really wanna get this right and need all the help I can get.