Dmann
Aquarium Advice Freak
- Joined
- Dec 19, 2012
- Messages
- 273
mr. X if you use the float switch method. The contair could go on the ground. And dont put the end in the water.
Chevy. There is a bulkhead fitting on the float valve. Drill a small hole in the sump where you want your water level. Install the float valve with the float inside the sump.
The lock line (water line/tube) (used in ice makers and water makers.) Inserts in the end of the float switch ( outside the sump)
The lock line is then run to a container thats just above the height of the float valve.
As your water evaperates, the float will drop. When the float drops it opens the water line slowly filling the sump. When the water rises the float goes up and closes the water line.
dino
Chevy. There is a bulkhead fitting on the float valve. Drill a small hole in the sump where you want your water level. Install the float valve with the float inside the sump.
The lock line (water line/tube) (used in ice makers and water makers.) Inserts in the end of the float switch ( outside the sump)
The lock line is then run to a container thats just above the height of the float valve.
As your water evaperates, the float will drop. When the float drops it opens the water line slowly filling the sump. When the water rises the float goes up and closes the water line.
dino