Recent content by Link119

You could use arduino if you know how to code in c++ and wire a pump. I guess it depends on how dedicated you are to do this. Basically you would want to use a thermistor (temperature based resistor) as a way to control the motor as an output.

Where are you putting the two contacts when you are measuring the voltage? I would test by plugging one pin into the ground of an household appliance plug (the circular prong below the two slots) and the other in the tank water. Anything above 10 volts or so means it is not safe if you are...

Some people prefer to dirt their aquarium. Its a cheap way to get a nutrient rich aquarium for heavy planting but it does come with its disadvantages. The two that come to mind (personally i only use PFS) are a heavy nutrient leak at first and its messy when uprooting plants.

Many times those large cfls dont fit in the hood. In my 10g hood even 13w bulbs barely fit and the hood also can get quite warm so personally i wouldnt recommend it. If i were you i'd probably get a t5ho fixture.

Java moss would be good for hiding your fry if you dont also need something that grows that quickly. It doesnt quite float but a ball of it would do quite nicely in a bottom corner of a tank to hide your fry. Its also pretty hard to kill

Both the color fade and on one particular fish there is a red spot in its belly. There are 4 of these rasboras in a 10 gallon with some plants.

I have 4 Chili Rasboras (or maybe they are Harlequins).

I dont have any dirt, but I do put root tabs beneath the plants that are root feeders. I've had horrible luck with both hornwort and anacharis and both of which made a huge mess when dying. I do not dose liquid ferts and am hoping to avoid that because I am off at college so I am trying to keep...

Since I started the aquarium, I always had an algae problem, mostly BGA. Now the sand has started to get some black algae growing on it much like how BGA grows but black. The tank is 10 gallons, very lightly planted (as seen in the photos), has two 13 watt spiral bulbs in the hood pointed...

There has been something going on with my Raspbora for quite a while (a few months or so) which i cant quite seem to figure out. The fish is acting quite normal but I dont know how long long it will live. What can I do to help it?

Are you saying that you PH has made it up to 8.5?

How about getting some fast growing plants? They should suck up nitrates fast.

I dont believe that a heater can be strained electronically especially because its job is to make heat. Most electronics have heat as a byproduct of trying to accomplish something else but since the heater is being cooled by the water, its not a problem if its continuously on. Whether or not...

I cant answer the first question but polyfill refers to polyester.

You are probably going through a minicycle (shown by cloudy water) and although adding the ceramic media may not help immediately, it is well worth getting. You will probably find it under "aquaclear 70 biomax" because the aquaclear 300 was renamed to 70. What are your water parameters? What is...