clownfish sleeping?

[54seaweed]

yes you used glass for the curved I'm just gonna use egg crate and no hinge how hard is it to glue flat edge? Just put a dab of super glue gel on each piece and stick the flat edge to then?

yes just like that
just takes patients getting it straight

 

[54seaweed]

if you find a sharp edge just file it with a nail file
but 99% of it has no sharp edges
the square mesh is about 7/16ths of a inch so it's almost a 1 out 100 chance you'll have a escapee

 

[kwandrsn]

Here is what I want to add
2 spotted cardinals
2 firefish
1 orange spotted goby
1 citrinis orange goby
1 six line wrasse

Would any of those be able to jump thru holes?

 

[54seaweed]

I haven't had any escapee's yet
they would have to hit the square whole dead on and thats a 1 in a million shot

 

[54seaweed]

the 2 fire fish may fight other than that your stock list looks good
I would do 1 fire fish
check out my profile for my stock list
maybe you will get ideas

 

[kwandrsn]

the 2 fire fish may fight other than that your stock list looks good
I would do 1 fire fish
check out my profile for my stock list
maybe you will get ideas

Ok thanks

 

[kwandrsn]

my clowns are getting where they are not as skittish I held a large flake in between my finger and held it under water and they both came up and ate off of it

 

[54seaweed]

All my fish eat out of my hand

 

[kwandrsn]

They are not as active today but they seem to be fine
Got my refractometer today and its saying 1.024 and the lfs said my hydrometer was off by 4 and I'm getting 1.021 on it

Ok my fault I was using the same pipette to do the distilled as well as salt.I used I regular eye dropper that I use to fill API tubes and rinse out and calibrated then used the pipette to do salt and I'm getting 1.025

 

[kwandrsn]

Here we go

 

[54seaweed]

Here we go


View attachment 148978



View attachment 148979





View attachment 148980

It turned out looking good

 

[kwandrsn]

It turned out looking good

Thank you. It didn't take long to make. I didn't glue a strip across bow side. Figured it would be a pain

 

[54seaweed]

either way turned out good

a lot cheaper than buying a top

 

[kwandrsn]

either way turned out good

a lot cheaper than buying a top

Yes only cost gas and $14.17 after tax

 

[kwandrsn]

I need something to go across the front between the light and the eggcrate. The eggcrate is really bright when you are staring at the tank

 

[54seaweed]

could always raise your light a hair and add a shade

sort of like this

 

[kwandrsn]

I figured I will get a piece of plexi or something and paint it black and slide it down between the legs and the light and notch the bottom to fit inside the eggcrate then when I want to remove it just slide it up. It will clear my access panel in the front so I can feed and stuff. I like holding the food and letting the fish eat

 

[Wolfsblood]

That turned out great! I am stoked to see this.