I've been trying to get some additional input on my custom sump/fuge. Since this is my first DIY project, I'm a bit intimidated.
I have a 90G reef tank... currently have a wet/dry.
The return pump will supply the phosban...
I still want to have the inlet "pour" over the LR. Just seems like a good idea. The inlet also supplies the refugium. I'll use a ball valve there.
The mag-drive pump that I'm lookin at is 4.5" wide. So, 6" in the return would allow for some breathing room, etc.
With these modifications, the refugium is ~10 gallons.
I should add... I'm still trying to figure out how to place filter pads / chemi-pure, etc.
Also... the last baffle before the return... Could I get rid of that baffle so that water comes in through the bottom?
I have a 90G reef tank... currently have a wet/dry.
The return pump will supply the phosban...
I still want to have the inlet "pour" over the LR. Just seems like a good idea. The inlet also supplies the refugium. I'll use a ball valve there.
The mag-drive pump that I'm lookin at is 4.5" wide. So, 6" in the return would allow for some breathing room, etc.
With these modifications, the refugium is ~10 gallons.
I should add... I'm still trying to figure out how to place filter pads / chemi-pure, etc.
Also... the last baffle before the return... Could I get rid of that baffle so that water comes in through the bottom?