tarheel92
Aquarium Advice Freak
So I just got my GLA Paintball CO2 regulator and have been trying to get it hooked up. I don't have a crescent wrench (am going to get one this evening) so it was only hand tightened to the tank, but I didn't hear any hissing so I figured it had created a tight enough seal.
When I hook it up to the 20 oz tank the tank pressure gauge reads right around 1000psi, I filled the bubble counter, turned the working pressure up to 35 psi per their instructions, plugged in the solenoid, and then started to open the needle valve but no bubbles were flowing through the bubble counter.
Is this an issue with the solenoid not opening? Is there just a pressure leak from it only being hand tightened and that's why it's not flowing? Anyone have any ideas?
When I hook it up to the 20 oz tank the tank pressure gauge reads right around 1000psi, I filled the bubble counter, turned the working pressure up to 35 psi per their instructions, plugged in the solenoid, and then started to open the needle valve but no bubbles were flowing through the bubble counter.
Is this an issue with the solenoid not opening? Is there just a pressure leak from it only being hand tightened and that's why it's not flowing? Anyone have any ideas?